Makita CG100DZC Instruction Manual page 7

Drip preventive function
The motor keeps running for a short time even after the
trigger is released. It releases the pressure of the caulk-
ing material and prevents dripping.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing 300 ml (10 fl
oz) size holder
Installing or removing the holder
joint
Attach the holder joint and plate by securing the screws
firmly. To remove the holder joint, follow the installation
procedure in reverse.
1 2
► 1. Screw 2. Plate 3. Holder joint
Installing or removing the rod and
piston
1. Insert the rod from the rear side of the tool with its
teeth facing down.
1
► 1. Short rod
2. Attach piston A with the screw.
3
1 2
► 1. Screw 2. Piston A 3. Short rod
NOTICE:
Available type of caulking material con-
tainer for 300 ml (10 fl oz) size holder is cartridge
only. Be sure to attach piston A to the rod.
To remove the rod and piston, follow the installation
procedure in reverse.
Installing or removing the holder
CAUTION:
Secure the holder to the holder
joint firmly. Otherwise the holder may come off
during operation and may cause an injury.
To install the holder, turn it clockwise firmly until it stops
while holding the holder joint. To remove the holder,
follow the installation procedure in reverse.
1
► 1. Holder
Installing or removing 600 ml (20 fl
oz) or 800 ml (29 fl oz) size holder
Installing or removing the holder
joint
Attach the holder joint and plate by securing the screws
firmly. To remove the holder joint, follow the installation
procedure in reverse.
7 ENGLISH
3