Control For Hdmi - Sony STR-DA5500ES Operating Instructions Manual

Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown on page 189. If
you connect the receiver to an outdoor
antenna (aerial), ground it against
lightning. To prevent a gas explosion, do
not connect the ground (earth) wire to a
gas pipe.
Outdoor FM antenna (aerial)
Receiver
Ground (earth)
wire (not supplied)
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.
• The signal strength of the stations is too
weak (when tuning in with automatic
tuning). Use direct tuning.
• Make sure you set the tuning interval
correctly (when tuning in AM stations
with direct tuning).
• No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations). Preset the
stations (page 71).
• Press DISPLAY so that the frequency
appears on the display.
The system cannot receive satellite
channels at all.
• The receiving condition is not good. Move
• Check that you subscribed to the desired
RDS does not work.
• Make sure that you are tuned to an FM
• Select a stronger FM station.
The RDS information that you want
does not appear.
• Contact the radio station and find out

Control for HDMI

The Control for HDMI function does not
To ground
work.
• Check the HDMI connection (page 33).
• Make sure "Control for HDMI" is set to
• Make sure the connected component is
• Check the Control for HDMI settings on
• If you change the HDMI connection,
• If you select "HDMI A" or "HDMI
the antenna to the place where the
condition is good.
satellite radio service (see page 73).
RDS station.
whether or not they actually provide the
service in question. If so, the service may
be temporarily out of order.
"ON" in HDMI settings menu.
compatible with the Control for HDMI
function.
the connected component. Refer to the
operating instructions of the connected
component.
connect/disconnect the AC power cord, or
there is a power failure, repeat the
procedures of "Preparing for the
"BRAVIA" Sync" (page 112).
A + B," after you have selected "HDMI B"
or "OFF," the Control for HDMI function
may not work properly for a while. This is
because the component connected to the
HDMI A jack must re-recognize the
receiver that is equipped with the Control
for HDMI function. If the Control for
continued
189 GB