Entering Diagnostic Mode And Checking The Codes; Resetting The Fault Codes; Exiting Diagnostic Mode - Toro Pro Force Debris Operator's Manual

Entering Diagnostic Mode
and Checking the Codes
1. Turn the ignition key to the S
2. Remove the tethered cap from the single-pin
connector and the single-socket connector
(Figure 54A).
3. Plug the single-pin connector into the
single-socket connector
Figure 54
4. Turn the key to the R
5. Watch the flash-pattern-sequence of the
diagnostic light for the following signals, then
consult the fault-code table:
•
The number and order of flashes in each
flash-pattern-sequence.
•
The order and length of time for each pause
in each flash-pattern-sequence.
Note:
If there are multiple machine faults active,
each fault will flash followed by a long pause.
After each active faults has been displayed, the
fault sequence will repeat. If no active faults
exist, the diagnostic light will flash continuously
once per second.

Resetting the Fault Codes

1. Turn the ignition key to the R
2. Remove the single-pin connector from the
single-socket connector
position.
TOP
(Figure 54B).
position.
UN
position .
UN
(Figure 55).
3. Plug the single-pin connector into the
single-socket connector
Note:
The diagnostic light continuously flashes
once per second.

Exiting Diagnostic Mode

1. Turn the key to the O
g029822
1. Ignition key
2. S position
TOP
2. Remove the single-pin connector from the
single-socket connector
40
Figure 55
(Figure 55).
position (Figure
FF
Figure 56
3. R /A
UN CCESSORY
4. S position
TART
(Figure 57).
g342081
56).
g341833
position