Table of Contents
Advertisement
battery compartment. If you install the batteries
improperly, you will not damage the machine,
but the handheld remote will not operate.
Figure 8
1. Positive battery polarity
3.
Ensure that the steel gasket and rubber seal
(Figure
7) are seated in the channel in the front
cover half.
4.
Align the lanyard ring over the lanyard pin
(Figure
7).
5.
Assemble the back cover to the and front cover
with 6 screws
(Figure
6.
Torque the screws to 1.5 to 1.7 N⋅m (13 to 15
in-lb).
7).
Product Overview
Controls
Handheld Remote
LED Light
The LED light indicates communication between
the handheld remote communication and the
wireless-control module
g341771
1. LED light
2. R
OTATE NOZZLE LEFT
button
3. D
ECREASE ENGINE SPEED
button
4. E
-
NGINE
START
Engine-Stop Button
g341769
Press the
ENGINE
(Figure
9).
Engine-Start Button
After preparing the machine for remote-control stating,
press the
ENGINE
(Figure
9). Refer to
for the starting sequence.
Blower Nozzle-Direction Button
Press the
ROTATE NOZZLE LEFT
button to rotate the blower nozzle to the
NOZZLE RIGHT
desired direction
Engine-Speed Button
•
Press the
INCREASE ENGINE SPEED
icon) to increase the speed of the engine
9).
11
(Figure
9).
Figure 9
5. R
OTATE NOZZLE RIGHT
button
6. I
NCREASE ENGINE SPEED
button
7. E
-
NGINE
STOP
button
-
button to shut off the engine
STOP
-
button to start the engine
START
Running the Engine (page 17)
button or the
(Figure
9).
button (rabbit
g029818
button
ROTATE
(Figure
Advertisement
Table of Contents
