Honeywell X-618 Installation Manual page 18

Public address and voice alarm system

Hide thumbs Also See for X-618:

Table of Contents

Figure 9 Connection Diagram of Amplifier and Control Port of DCS

Connecting the DA audio output to the DCS

Strip one end of the prepared audio output cable jacket by 10mm, and feed the cable

through the protective cover of the power amplifier.

Figure 10 Schematic Diagram of a Feeding the Audio Output Cable through the Protective

Take the end of the cable that was fed through the protective cover of the power amplifier

wiring terminal connect the cable to the power amplifier output wiring terminal (7P green

phoenix tail seating 5.08mm), and tighten the screws. Refer to 0 .

Figure 11 Connecting the Audio Output Cable to the Power Amplifier Input Wiring Terminal

Feed the other end of the audio output cable through the DCS protective cover of the

terminal.

Connect the end of the cable that was fed through the protective cover of the DCS to the

power amplifier input wiring terminal (4P green phoenix tail seating 5.08mm), and tighten

the screws. Refer to 0.

Terminal Cover

Table of Contents