Specifications; Intended Use; Power Supply - Makita LS0815F Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Blade diameter
Hole diameter
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Laser type
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Max. Cutting capacities (H x W) with 216 mm in diameter
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
DOUBLE INSULATION
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
Adjust sliding fences clear of blade and
blade guard properly.
LASER RADIATION: Do not stare into
beam. Direct laser beam may injure your
eyes.
Countries other than Europe
European countries
Miter angle
0°
45°
60° (right)
LS0815F
-
755 mm x 450 mm x 488 mm
45° (left)
50 mm x 305 mm
50 mm x 215 mm
-
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately and
returned to an environmentally compatible
recycling facility.

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
9 ENGLISH
LS0815FL
216 mm
25.4 mm or 30 mm
(country specific)
30 mm
2.8 mm
Right 60°, Left 50°
Right 5°, Left 48°
-1
5,000 min
Red Laser 650 nm, Maximum output
1 mW ( Laser Class 2M )
15.5 kg
/II
Bevel angle
5° (right)
60 mm x 305 mm 65 mm x 305 mm
- 65 mm x 215 mm
- 65 mm x 150 mm
0°