Honeywell CD3000M User Manual page 45

Honeywell
9.3.8 Command Table
Bit Meaning
0 HB Calibration
1 Firing command
2 On-Off
3 RESET HB
N.B.: When unit is switch off all command parameter are set to 0
HB Calibration
9.3.8.1
Operations: Read / Write
Meaning:
It's a bit that starts the HB calibration procedure
When this bit is zero start the calibration procedure and reset itself automatically at the end.
Firing command
9.3.8.2
Operations: Read / Write
Meaning:
It's a command bit used to switch from analog external command to command via RS485
0 = Command of analog input
1 = Command of RS485 input
On-Off
9.3.8.3
Operations: Read / Write
Meaning:
Its' an enable bit to switch ON-OFF the power.
0 = Power disabled
1 = Power enabled
HB RESET
9.3.8.4
Operations: Read / Write
Meaning:
It's a command bit to reset HB alarm.
This parameter has to be at 0 to have the alarm working properly
0 = Reset disabled
1 = Reset enabled
www.honeywell.com/imc
CD3000M-1PH from 125A to 700A
Notes
Read /write
( normal mode set to 0)
Read /write
Read /write
Read /write
( normal mode set to 0)
44
0=Off - 1=ACTVATE Calibration
0=from terminal -
0=Off -
0=Off -
User's Manual
1=from RS485
1=On
1=RESET
Bit 0
Bit 1
Bit 2
Bit 3