Power - Canon WUX5000 User Commands

POWER

This controls the power supply
Format
POWER□<Parameter:ID>
GET□POWER / ?△POWER
<Parameter:ID>
ON
OFF
Environment
Power
OFF ON PM D-RGB
-
Response
"i:OK" is returned if the parameter was set properly.
For ' ' or '
GET POWER ?POWER
Response
'g:POWER=OFF'
'g:POWER=OFF2ON'
'g:POWER=ON'
g:POWER=ON2PMM'
'g:POWER=PMM'
'g:POWER=PMM2ON'
'g:POWER=ON2OFF'
For details on other responses, refer to the "Error List".
Description
(1) This performs ON / OFF control of the power supply.
(2) This command is identical to pressing the POWER button on the remote control.
(3) Processing of other commands (including ZOOM / FOCUS) will be interrupted at "POWER
OFF" when the power is ON.
(4) 'i:BUSY' will be returned at "POWER ON" during power OFF transition. For other cases,
'i:OK' will always be returned.
(5) The current power supply status can be referenced using the applicable GET command. ("
(6) After sending this command, use GET POWER to obtain the power supply state at regular
intervals, and check that it is in the controlled state (off or on).
(7) Even when it is powered up by using this command, "Prepare for lamp replacement", "Lamp
replacement warning", "Clean filter warning" will display for 10 seconds as usual.
Example
Control
> POWER ON
< i:OK
Reference
> GET POWER or ?POWER
< g:POWER=OFF
* Commands are indicated by ">", and responses are indicated by "<".
Power ON
Power OFF
Input
A-RGB COMP HDMI None
-
', current power supply status is returned as shown in the table below.
Status
OFF
OFF -> ON in transition
ON
ON -> Standby in transition
Standby
Standby -> ON in transition
ON -> OFF in transition
- 52 -
WUX5000 / WUX4000 User Commands
")
GET POWER