Siemens 6SN1123-1AA00-0DA2 Configuration Manual page 96

Simodrive 611 series drive converter
Table of Contents

Advertisement

02.03
05.01
Optional terminal
An additional 8 digital inputs and outputs can be realized using this optional
module.
module
The functionality of these inputs/outputs can be freely parameterized.
Note
S
S
I4
X422
I5
8 inputs
I6
I7
I8
I9
I10
I11
O4
O5
O6
O7
O8
O9
X432
O10
8 outputs
O11
Fig. 4-6
Optional TERMINAL module
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
4.2 "SIMODRIVE 611 universal HRS" control board
The input/output terminals of the optional TERMINAL module are
– Before SW 4.1: permanently assigned to drive A or axis A
– As of SW 4.1: can be freely assigned axes
The optional TERMINAL module can be used as follows, dependent on the
software release:
– The following applies before SW 2.4:
The module can only be used in the "positioning" mode.
– The following applies as of SW 2.4:
The module can be used independently of the operating mode.
Order number: 6SN1114–0NA00–0AA0
4 Control Units
For screws:
Tighten (due to the shield contact)
max. torque = 0.8 Nm
4
4-95

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents