Table of Contents
Advertisement
75
User Manual of IR Network Speed Dome
2. Check the Enable Video Loss Detection checkbox to enable the video loss
detection.
3. Click
to edit the arming schedule for video loss detection. The
arming schedule configuration is the same as the setting of the arming schedule for
motion detection. Refer to Step 2 Set the Arming Schedule for Motion Detection in
Section 6.6.1.
4. Check the checkbox to select the linkage method taken for the video loss alarm.
Notify surveillance center, send email and trigger alarm output are selectable. Please
Step 3 Set the Alarm Actions for Motion Detection in Section 6.6.1.
5. Click
to save the settings.
6.6.3 Configuring Video Tampering Alarm
Purpose:
You can configure the speed dome to trigger the alarm actions when the lens is
covered.
Steps:
1. Enter the tampering Settings interface:
Configuration > Advanced Configuration > Events > Video Tampering
Figure 6-45 Tamper-proof Alarm
2. Check Enable Video Tampering checkbox to enable the tampering detection.
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
www.cctvireland.ie
Advertisement
Table of Contents
