Sanyo PLC-XP200L Owner's Manual page 33

MOUSE POINTER button
Move the pointer on the screen with this button.
POINTER button
Press POINTER button on the remote control to display the
Pointer on the screen.
P-TIMER button
Press the P-TIMER button on the remote control. The Timer
display "00 : 00" appears on the screen and starts to count
time (00 : 00–59 : 59).
To stop the P-TIMER, press the P-TIMER button.
To cancel the P-TIMER, press the P-TIMER button again.
P-Timer display
FREEZE button
Press the FREEZE button on the remote control to freeze
the picture on the screen. To cancel the FREEZE function,
press the FREEZE button again or press any other button.
FILTER button
Press and hold the FILTER button for more than five seconds
to operate electrically operated filter to replace the filter.
✔
Note:
• The filter cannot be rewound.
• When the filter is replaced, the total accumulated time of the filter
use is automatically set to 0.
KEySTONE button
Press the KEYSTONE button on the remote control. The
"Keystone" appears on the screen.
Use the Point ed7 8 buttons to correct keystone
distortion. The keystone adjustment can be stored (pp.44,
48).
Reduce the upper width with
Point button.
e
Reduce the lower width
with Point button.
d
Remote Control
KEySTONE
button
✔ Note:
• See the previous page for the
description of other buttons.
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control again while the Keystone dialog box is being
displayed, the keystone adjustment will be canceled.
• The adjustable range can be limited depending on the
input signal.
• "Keystone" disappears after 10 seconds.
Reduce the left part with
Point button.
7
Basic Operation
MOUSE
POINTER
button
POINTER button
P-TIMER button
FREEZE button
FILTER button
Reduce the right part with
Point button.
8
33