Power - JVC GR-D728EK Instructions Manual

Power

Charging The Battery Pack
Battery pack mount
1
Arrow
Battery
pack
BATT
Lock
button
Power switch
To AC outlet
1
Set the Power Switch to "OFF".
2
With the arrow on the battery pack pointing
upward, push the battery pack slightly against
the battery pack mount a.
3
Slide up the battery pack until it locks in
place b.
4
Connect the Power Cord to the AC Adapter.
5
Plug the AC Adapter into an AC outlet.
6
Connect the AC Adapter to the camcorder.
● The POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
● When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC Adapter from
the AC outlet. Disconnect the AC Adapter from the
camcorder.
POWER/
CHARGE lamp
2
To DC
connector
AC Adapter
GETTING STARTED
To detach the battery pack
Slide the battery pack upward while pressing
BATT. to detach it.
Battery pack
BN-VF808U*
BN-VF815U
BN-VF823U
* Provided
NOTES:
● If the protective cap is attached to the battery
pack, remove it first.
● During charging, the camcorder cannot be
operated.
● Charging is not possible if the wrong type of
battery is used.
● When charging the battery pack for the first time
or after a long storage period, the POWER/
CHARGE lamp may not light. In this case, remove
the battery pack from the camcorder, then try
charging again.
● If a fully charged battery pack is attached to the
unit, POWER/CHARGE lamp will blink for approx.
10 seconds before it turns off.
● If the battery operation time remains extremely
short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.
● Since the AC Adapter processes electricity
internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.
● After 5 minutes have elapsed in Record-Standby
mode with the cassette inserted, and no operation
is performed, the camcorder will automatically turn
off its power supplied from the AC Adapter. In this
case, the battery charge starts if the battery is
attached to the camcorder.
● Please do not pull or bend the AC Adapter plug
and cable. This may damage the AC Adapter.
EN
Charging time
Approx. 1 hr. 30 min.
Approx. 2 hrs. 40 min.
Approx. 3 hrs. 50 min.
CONTINUED ON NEXT PAGE
13