Table of Contents
Advertisement
• The Pass list / Block list dialog will be shown
(page
2.
Choose the type of list to be uploaded by clicking the correct List
Type: radio button.
3.
Click the Choose File button. Upload the saved *.CSV file using
the upload dialog.
• The contents of the uploaded *.CSV file will be shown in
the Pass list / Block list Status section.
To apply the list settings contained in the *.CSV file, click the Apply
Settings button.
To clear the Pass list or Block list settings without deleting the *.CSV file,
click the Clear Pass list or Block list button.
To delete the Pass list or Block list *.CSV file, click the Reset button.
7.6.5. Multicast
Multicast management for mesh network-capable devices
Multicast is a group-communication method in which data transmissions
are addressed simultaneously to more than one destination computer.
Multicast transmissions can be point-to-multipoint, or multipoint-to-
multipoint.
By default, if CCTV cameras and devices that operate in a similar fashion
are linked to a Cisco transceiver unit operating in Mesh Point mode,the
unit forwards all multicast traffic generated by the cameras to the
closest Mesh End unit in the wireless network.
However, depending on network configuration, it may be convenient to
forward multicast traffic from one Mesh Point unit to another Mesh Point
unit, to allow such tasks as remote recording of the video data flow.
By default, units operating in Mesh End mode do not forward multicast
traffic to a wireless network. The only exceptions to this rule are universal
plug and play (UPnP) and Internet Group Management Protocol (IGMP)
traffic.
To redirect traffic flow to a Mesh Point unit, all multicast flow redirection
information must be specified using the Multicast settings on a Mesh End
unit.
NOTE
To change the unit's Multicast settings, make sure that the unit
is in Mesh End mode as shown in
mode" (page
is set to Mesh Point mode.
To set multicast rules on a Mesh End unit, do the following steps:
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
112)).
71). Multicast controls are not available if the unit
(Figure 40
"Changing the operational
Page 113 of 189
Advertisement
Table of Contents
