Table of Contents
Advertisement
Blade Guard
Assembly
the term "blade guard" refers to the assembly
that consists of the clear polycarbonate shield, the
spreader, and the anti-kickback pawls on each
side of the spreader (Figure 48). each of these
components has important safety functions during
the operation of the saw.
Figure 48. Blade guard assembly components.
Guard
the clear polycarbonate guard allows the opera-
tor to see the blade cut the workpiece during
operation. this guard is designed to lift as the
workpiece is pushed into the blade and remain in
contact with the workpiece throughout the entire
cut.
the guard reduces injury risk by providing a bar-
rier around the blade that prevents accidental
contact and contains flying wood chips.
to ensure that the guard does its job effectively,
it must always be in the downward position
against the table during idle operation, and the
hinge mechanism must be maintained in good
working condition so the guard can freely pivot
up and down to accommodate the height of the
workpiece and return to the table surface.
Spreader
the spreader is a metal plate that prevents the
newly cut kerf of the workpiece from pinching the
backside of the blade, causing kickback.
the spreader also acts as a barrier behind the
blade to shield hands from being pulled into the
blade if a kickback occurs.
-38-
In order to work properly, the spreader
cannot be bent or misaligned with the blade.
If the spreader gets accidentally bent, take
the time to straighten it or just replace it.
using a bent or misaligned spreader will
increase the risk of kickback!
To ensure that the blade spreader works
safely, the specifications listed in Blade
Requirements on page 36 MuST be met
when installing new blades.
The spreader MuST be aligned/adjusted to
the blade. These requirements do not apply
to dado blades.
Installing Blade Guard & Spreader
1.
disConneCt saW From poWer!
2.
remove the table insert.
3.
insert the spreader into the bracket slot and
tighten the lock knob shown in Figure 49 to
secure the spreader.
Figure 49. location to secure blade guard.
4.
tug the spreader up to verify it is locked.
model g0651/g0652 (mfg. since 1/10)
lock Knob
Advertisement
Table of Contents
