Table of Contents
Advertisement
BEFORE FIRST USE
Frequency
Protocol
Max Power
5.4 Initial preheating
Preheat the empty oven before the first use.
Step 1
Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventila‐
ted.
5.5 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper supplied with the steam set.
Step 1
Put the test paper
into water for about
1 sec. Do not put
the test paper under
running water.
The colours of the test paper continue to change. Do not check water hardness later than 1
min after test.
16/64
Step 2
Shake the test paper
to remove the excess
of water.
2.4 GHz WLAN
2412 - 2484 MHz
IEEE 802.11b DSSS/802.11g/n OFDM
EIRP < 20 dBm (100 mW)
.
.
Step 3
After 1 min, check
water hardness with
the table below.
Step 4
Set the water hardness
level: Menu / Settings /
Setup / Water hard‐
ness.
Advertisement
Table of Contents
