7.17. Removal of the V1-Board and the V2-Board
1. Lay down the front frame on the flat surface of the table (covered by a soft cloth
not to damage the surface.)
2. Remove the couplers (V2 on the V1-Board and V15 on the V2-Board).
3. Unscrew the screws (×3 ).
4. Remove the V1-Board, the V2-Board hold bracket and the V2-Board.
7.18. Removal of stand brackets
1. Remove the plasma panel section from the servicing stand and lay on a table
(covered), with the plasma panel surface facing downward.
Spread a soft cloth for protection, to prevent panel surface from scratching.
2. Remove the stand bracket (left, right) fastening screws (×4
the stand brackets (left, right).
36
each) and remove