Functional Description; Operation - Makita DP3002 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function
on the tool.
Switch action
Fig.1
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push the lock lever upward.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Reversing switch action
Fig.2
This tool has a reversing switch to change the rotational
direction. Move the reversing switch lever to the
(A side) for clockwise (forward) rotation or the
(B side) for counterclockwise (reverse) rotation.
CAUTION:
Always check the rotational direction before
•

operation.

Use the reversing switch only after the tool comes to
•
a complete stop. It will damage the tool to change
the rotational direction before the tool stops.
Hook
Fig.3
Fig.4
When using the hook, pull it out in "A" direction and then
push it in "B" direction to secure in place.
When not using the hook, return it back to its initial
position by following the above procedures in reverse.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (auxiliary handle)
Fig.5
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel.
Then tighten the grip by turning clockwise at the desired
position. It may be swung 360° so as to be secured at
any position.
Installing or removing drill bit
For Model DP3003, DP4001, DP4003
Fig.6
Hold the ring and turn the sleeve counterclockwise to
open the chuck jaws. Place the bit in the chuck as far as
it will go. Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve
counterclockwise.
For Model DP3002, DP4000, DP4002
Fig.7
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each
of the three holes and tighten clockwise. Be sure to
tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise
in just one hole, then loosen the chuck by hand.
After using the chuck key, be sure to return to the
original position.
Depth gauge (optional accessory)
The depth gauge is convenient for drilling holes of
uniform depth. Loosen the side grip and insert the depth
gauge into the hole in the side grip. Adjust the depth
gauge to the desired depth and tighten the side grip.
position
position
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the tool
body.
Fig.8
OPERATION
Holding tool
Holding against a stud
1
003076
Holding against a floor
1
2
003077
Always use the side grip (auxiliary handle) and firmly
hold the tool by side grip and switch handle during
operations.
5
1
2
3
1. Reaction
2. Reverse
3. Forward
1. Forward
2. Reaction