Makita XBU02 Repair Manual page 3

R
epair
[3] DISASSEMBLY/ASSEEMBLY
[3] -1. Fan 110, Rotor (cont.)
DISASSEMBLING
(2) Separate Motor housing from Housing set L. (Fig. 2)
Fig. 2
While paying attention not to loosen Switch section in Handle portion,
separate Motor housing section from Housing set L.
Fan 110 is removed from
this side in the next step.
(3) Remove M5 Coned disc spring hex nut from the rotor shaft and remove Fan 110. (Fig. 3)
Fig. 3
2. Lock Fan 110 with the grip of plastic hammer,
and then remove M5 Coned disc spring hex nut
from the rotor shaft by turning it counterclockwise
with the impact driver.
M5 Coned disc spring hex nut
3. Remove Fan
110 by hand.
Switch section
Housing set L
Grip of plastic
hammer
Fan 110
Fan 110
Motor housing
1. Attach Socket bit 8-55 to an impact driver
to remove M5 Coned disc spring hex nut.
Socket bit 8-55
8 mm
55 mm
M5 Coned disc
spring hex nut
4. Fan 110 can be
removed using 1R045,
if it is difficult to
remove by hand.
P 3/ 13
Flat washer 5
Note: Make sure not to
lose Flat washer 5.
1R045