Mounting - Honeywell SAT-IDP Series User Manual

3.4 Mounting


If possible, try the installation before drilling any holes or fixing cable.

Record the unit ISN number (Inmarsat Serial Number) for future reference.

Fit the supplied rubber pads to the base of the SAT-401E to avoid damage to the vehicle.

The SAT-IDP and SAT-401C variants may be mounted by using either the three outer M4 mounting
holes or the M25 thread on the base.

The SAT-IDP-SC, SAT-401E is designed as a portable solution and does not require permanent fitting.

If using the three outer mounting holes (recommended for installations exposed to shock and/or high
vibration and/or uneven surfaces):
o Bore a central 40mm hole.
o Position the terminal centrally and mark the location of the three mounting holes.
o Drill three 4.5mm mounting holes.
o Secure the terminal in place using M4 (No.8) nuts and bolts - Do not over tighten (1.5Nm Max)
o Alternatively, secure using fastenings appropriate to the mounting surface - Do not over
tighten (1.5Nm Max).

If using the M25 base mounting thread:
o Bore a 26mm hole to pass the connector (SAT-IDP only) and mounting thread through (and
cable on SAT-401C model).
o Secure using M25 nut - Do not over tighten (2.0Nm Max).

Do not paint the SAT-IDP enclosure.

Do not attach any foreign object to the enclosure anywhere above the three outer mounting holes.
MAN-0077 Honeywell Global Tracking Ltd 10