Led Indication - Canon PS-7000 Service Manual

2. LED Indication

2.1. LED Indication
Conditions
Normal
During initialization following power-on
During access to HDD
Ready
Receiving job from the host (computer)
Waiting for job from the host (computer)
Processing PS data (job)
Standby for process of PS data (job)
Processing non-PS data (job)
Standby for process of non-PS data (job)
Sending data to the printer
(Outputting job)
Waiting to send data to the printer
(Waiting to output job)
Error
PS Error
Fatal Error 1
Unexpected error during operation.
Fatal Error 2
Defect detected in self-test at start-up.
Fatal Error 3
No operation of hardware
How to Handle Errors
PS Error : It is a software error. Check the image data being processed.
Fatal Error 1 : Errors are supposed to arise from the operating environment or be caused by temporary
Fatal Error 2 : Improper insertion of the Memory SIMM is suspected. Perform the DIAG program and
Fatal Error 3 : If the DIAG program cannot be performed, replace a unit one by one to narrow down
noise. Turn off the power and turn it on again, or check the operating environment.
identify the problem.
to the cause of problem.
Power HDD
LED LED
Receiving
1)The Power LED turns red immediately after power-on.
2)All the LEDs turn orange for 500ms.
3)The Power LED turn green, with the other LEDs turned off.
Green Green
Green Off
Green --
Green --
Green --
Green --
Green --
Green --
Green --
Green --
Green --
Red Off
Red Off
Red Off
--: Turning on or off according to jog progress.
3-9
Chapter 3 Troubleshooting
Status LED
Processing
-- --
Off Off
Green
--
flashing
Green --
Green
--
flashing
-- Green
Orange
--
flashing
-- Orange
-- --
-- --
-- Red
Off Red
Red Off
Off Off
Printing
--
Off
--
--
--
--
--
--
Green
flashing
Green
--
Off
Off
Off