Specifications - Makita M6600 Instruction Manual

ENGLISH (Original instructions)
1-1. Lock button
1-2. Switch trigger
2-1. Hex nut
2-2. Shaft
2-3. Shaft holder
3-1. Wrench
3-2. Shaft holder

SPECIFICATIONS

Mixing blade diameter
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for mixing wall materials, etc.
(except flammable materials)
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
3-3. Wrench
5-1. Mixing blade
5-2. Shaft
5-3. Hex bolt
7-1. Leaf spring
7-2. Rear handle
7-3. Boss
Model
No load speed
Overall length
Net weight
Safety class
noise level determined
) : 85 dB (A)
pA
) : 96 dB (A)
WA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
ENE056-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENF002-2
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG905-1
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Mixer
Model No./ Type: M6600
Conforms to the following European Directives:
ENG900-1
2006/42/EC
They are manufactured in accordance with the following
sum)
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
ENG901-1
3
8-1. Rear handle
8-2. Screw
10-1. Limit mark
11-1. Brush holder cap
11-2. Screwdriver
M6600
-1
0 - 700 min
165 mm
280 mm
3.4 kg
/II
ENH101-18