※ For some model (NO
Handle to
Counterclockwise direction
=> to release saw blade tension
Handle to C
lockwise direction
=> to tighten saw blade tension
Step 7 - Open the idler and drive wheel covers.
Step 8 – Slightly open the Blade Clip (Blade holder) device to release the blade. (optional)
Step 9 - Loosen the left and right carbide inserts by
Step 10 - Loosen the lock lever and lower the wire brush; Open the wire brush cover (if necessary).
Step 11 – Uninstall protection cover of Anti-Vibration Damper (if necessary)
。 (optional)
old blade
Tension Controller Handle
Shown):
Blade Clip Device (optional)
loosening the "lock nut"
Lock Nut
Wire Brush Case
Lock Lever
protection cover of
Anti-Vibration Damper
shown below.
for easily taking out the
4-25