Troubleshooting - AEG BEB230010M User Manual

28 www.aeg.com
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
Do not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller
panel first, then the larger and the door.
Make sure that the glasses are inserted in
the correct position otherwise the
surface of the door may overheat.
9.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.

10. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
10.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
1. Turn off the oven. Wait until the oven
is cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the
cavity.
The top lamp
1. Turn the lamp glass cover to remove
it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.
Possible cause
The oven is deactivated.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
Remedy
Activate the oven.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.