Lights - Yamaha SR10ARLG Owner's Manual

Rear spring pre-load adjustment is
accomplished by rotating the adjusting
cams. Position 3 provides the stiffest
ride, and position 1 is for the light driver
or slowspeed trail riding. Position 2 is for
the average operator under normal condi-
tions. Always rotate the cam from the
lighter position to the heavier position.
CAUTION
Never force the adjustment cams
from the low position to the high
position. Cam damage may occur.
Position 2
Adjusting Cam
To rotate an adjusting cam, use the spark
plug wrench from the tool kit. Rotate the
wrench until the cam is in the desired
position. To stiffen the ride, rotate the
cam so as to raise the spring end. Make
the appropriate adjustment on the other
cam.

Lights

For the correct headlight bulb and/or tail-
light/brakelight LED, see the appropriate
specifications sheet.
Removing and Installing Taillight/
Brakelight
These models are equipped with an LED
taillight/brakelight. If the LED fails, it
must be replaced.
1. Disconnect the taillight harness con-
nector.
2. Remove the two machine screws
securing the taillight to the bracket.
Position 3
Position 1
741-450A
Machine Screw
3. Connect the taillight harness connec-
tor; then secure the taillight to the
bracket with the two screws.
Removing/Installing Headlight
Bulb

NOTE: The bulb portion of head-
light is fragile. HANDLE WITH CARE.
When replacing the headlight bulb,
the bulb assembly must first be
removed from the housing. Do not
touch the glass portion of the bulb. If
the glass is touched, it must be
cleaned with a dry cloth before
installing.
1. Disconnect the headlight harness
connector from the bulb; then
remove the rubber grommet from
the headlight housing.
2. Rotate the bulb retainer counter-
clockwise until it unlocks from the
housing; then remove the bulb.
Headlight Bulb Retainer
Headlight Bulb
3. Install the bulb and retainer; then
rotate the retainer clockwise until it
properly locks in place.
4. Install the rubber grommet; then
connect the headlight harness con-
nector to the bulb.
Taillight
SNO-511
Grommet
Headlight Harness
0747-832
38