Fuses - Yamaha SR10ARLG Owner's Manual

10. Secure the red positive cable to the
positive terminal on the battery
using a cap screw, lock washer, and
a flat washer. Tighten securely.
11. Secure the main black negative
cable and the small black negative
cable to the battery using a cap
screw, lock washer, and a flat
washer. Tighten securely.
CAUTION
Connecting cables in reverse (pos-
itive to negative and negative to
positive) can cause serious dam-
age to the electrical system.

NOTE: Assure the harness wires
and cables are routed properly as
noted during removing battery proce-
dure.
12. Install the battery bracket/solenoid
and tighten the two screws and lock
nuts to 1.2 kg-m (105 in.-lb); then
install the seat and secure with the
torx-head screw. Tighten securely.

NOTE: Prior to lowering and
securing the seat, connect the seat
heater harness connector.

Fuses

Fuses protect the snowmobile electrical
system from overloading. If electrical
parts in the snowmobile are not working,
the system may have been overloaded and
caused a blown fuse. Before repairing or
replacing any electrical part, check the
appropriate fuses. If a fuse blows (opens a
circuit), all the parts of the snowmobile
that use that circuit will not work.
Once which fuse to check has been deter-
mined, perform the following steps:
27
1. Locate the fuse block and remove

the coolant overflow bottle.

beneath the fuse block cover.
2. Remove the suspected fuse.

tions are next to the fuse contacts
Cable Tie
in the fuse block.
3. Look through the clear side of the
XM167A
Always replace a fuse with one hav-
ing the same specified amperage
rating. Using a fuse with a higher
rating can cause severe wire dam-
age and could start a fire.
4. Install the fuse block cover and close
Even after replacing a fuse, it may conti-
nue to blow if the cause of the overload is
not determined. If the fuse continues to
blow, take the snowmobile to an autho-
rized Yamaha Snowmobile dealer for ser-
vice. If not under warranty, this service is
at the discretion and expense of the
snowmobile owner.
the fuse block cover.
NOTE: The fuse block is behind
NOTE: There are spare fuses
NOTE: Fuse function descrip-
fuse to see if the element inside is
burned or separated. If it is, the fuse is
blown and should be replaced with a
fuse of the correct amperage rating.
WARNING
the access panel.
XM124A