Access Panel/Hood; Removable Seat - Yamaha SR10ARLG Owner's Manual

Access Panel/Hood

To remove the access panel and hood, use
the following procedure:
1. Remove the hairpin clip from the pin
located at the front of the access
panel. Remove the thumb screw
securing the front left access panel
to the front fascia. Move the panel
up and off the pin; then swing the
panel all the way out and unhinge
the panel from the lower console.
2. Remove the torx-head screws secur-
ing the hood (located on the underside
of the hood above the front tube of the
upper A-arm); then remove the torx-
head screws from the top-side of the
hood securing the hood to the upper
console and the torx-head screws
from under the nosepiece of the hood.
Torx Head Screws
3. Remove the intake panel below the
gauge; then locate the hood harness
connector (located in front of the
speedometer) and unplug the con-
nector; then move the hood slightly
forward and remove the hood.
To install the access panel and hood, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector making sure the harness
does not become pinched.
2. Secure the hood with torx-head
screws and tighten securely.
3. Install the access panel onto the
lower console; then close the access
panel and secure with the hairpin
clip. Install the intake panel.
13

Removable Seat

To remove the seat, remove the torx-head
screw from the underside of the seat; then
lift on the back of the seat and move it up
and rearward to remove it.
Prior to removing the seat, lift the
rear of the seat and disconnect the
seat heater harness connector.
Torx Head Screw
To install the seat, route the front tab on
the seat through the seat-base hold-down
bracket; then install the seat and secure
using the torx-head screw.
Torx Head Screw
0747-830

securing the seat, connect the seat
heater harness connector.

pull back on the seat retainer pin
and remove the seat. Make sure to
disconnect the seat heater har-
ness.
CAUTION
NOTE: Prior to lowering and
NOTE: On SR10SD46 models,
Torx Head Screw
0747-739
SNO-273