Power Trim And Tilt Switch On Remote Control Or Tiller Handle; Power Trim And Tilt Switch On Bottom Cowling - Yamaha F115 Owner's Manual

Components
To increase resistance, turn the lever to the
port side "A".
To decrease resistance, turn the lever to the
starboard side "B".
EWM00040
WARNING
Do not overtighten the friction adjuster. If
there is too much resistance, it could be
difficult to steer, which could result in an
accident.
TIP:
Check the tiller handle for smooth move-
G
ment when the lever is turned to the star-
board side "B".
Do not apply lubricants such as grease to
G
the friction areas of the steering friction ad-
juster.
EMU26143
Power trim and tilt switch on remote
control or tiller handle
The power trim and tilt system adjusts the out-
board motor angle in relation to the transom.
Pressing the switch "
board motor up, and then tilts it up. Pressing
the switch " " (down) tilts the outboard motor
down and trims it down. When the switch is re-
leased, the outboard motor will stop in its cur-
rent position.
For instructions on using the power trim and
tilt switch, see pages 77 and 79.
40
" (up) trims the out-
EMU26155
Power trim and tilt switch on bottom
cowling
The power trim and tilt switch is located on the
side of the bottom cowling. Pushing the switch
" " (up) trims the outboard motor up, and
then tilts it up. Pushing the switch "
tilts the outboard motor down and trims it
down. When the switch is released, the out-
board motor will stop in its current position.
For instructions on using the power trim and
tilt switch, see page 79.
EWM01031
WARNING
Use the power trim and tilt switch located
on the bottom cowling only when the boat
is at a complete stop with the engine off.
Attempting to use this switch while the
boat is moving could increase the risk of
" (down)