Receiver (If Equipped); Yamaha Security System Lock And Unlock Mode (If Equipped) - Yamaha F115 Owner's Manual

Components
and then check that it is operating prop-
erly. If the transmitter is not operating
properly, contact a Yamaha dealer.
Keep the remote control transmitter
G
away from high temperatures and do not
place it in direct sunlight.
Do not drop the remote control transmit-
G
ter, subject it to strong shocks, or place
any heavy items on it.
Use a soft, dry cloth to clean the remote
G
control transmitter. Do not use deter-
gent, alcohol, or other chemicals.
Do not attempt to disassemble the re-
G
mote control transmitter yourself. Other-
wise, the transmitter may not operate
properly. If the transmitter needs a new
battery, contact a Yamaha dealer.
If you have lost the remote control trans-
G
mitter, consult your Yamaha dealer.
Keep the least 2 transmitters at all the
time. If you have lost both transmitters,
consult your Yamaha dealer.
TIP:
Since the receiver is programmed to recog-
G
nize the internal code from this transmitter
only, the security system setting can only
be changed with this transmitter. If the re-
mote control transmitter does not operate
properly, contact a Yamaha dealer.
Replace the battery cell after 1 year, and
G
every two years thereafter as a standard
measure.
Refer to local hazardous waste regulations
G
when disposing of transmitter batteries.
The Yamaha Security System permits to
G
register up to 5 remote control transmitters.
Consult your yamaha dealer for details.
34
EMU38601

Receiver (if equipped)

The receiver control the ECM (Electronic con-
trol module) to prevent the engine from start-
ing. Consult your Yamaha dealer for
installation of the receiver.
EMU38611
Yamaha Security System lock and un-
lock mode (if equipped)
The Yamaha Security System settings are se-
lected by pressing the lock or unlock button
on the remote control transmitter briefly.
1
1. Lock button
2. Unlock button
LOCK
When the lock button on the remote control
transmitter is pressed briefly, the beeper
sounds once. This indicates the lock mode is
selected and the engine cannot be started.
The lock mode is selected only when the main
switch is in the " " (off) position. The engine
cranks but can not be started while the
Yamaha Security System is on lock mode.
UNLOCK
When the unlock button on the remote control
transmitter is pressed briefly, the beeper
sounds twice. This indicates the unlock mode
is selected and the engine can be started.
2
ZMU06456