Advertisement
154568/3208-220
5/17/02
1:36 PM
Page 2
Motor
Figure 1
Your B&D tool is powered by a B&D built motor. Be sure your power supply
agrees with the nameplate marking. Voltage decrease of more than 10% will
cause loss of power and overheating. All B&D tools are factory tested; if this
tool does not operate, check the power supply.
LOCK
Figure 2
Switch
BUTTON
HOUSING
To start tool, depress trigger switch. To stop tool, release the trigger.
To lock the trigger in the on position for continuous operation, depress
trigger, push up the lock button (Figure 1), and gently release the trigger. To
release the locking mechanism, depress the trigger fully, then release it.
Before using the tool each time, be sure that the lock button release mecha-
nism is working freely. Be sure to release the switch lock button before dis-
CAP SCREWS
connecting the plug from the power supply. Failure to do so will cause the
tool to start immediately the next time it is plugged in. Damage or injury
could result. The variable speed trigger switch permits speed control. The
farther the trigger is depressed, the higher the speed of the shear.
WASHER
Disassembly and Assembly
(Figures 2 and 3)
LEFT SIDE KNIFE
ECCENTRIC BEARING
To remove shear head from motor, loosen 3 cap screws. Remove shear
ASSEMBLY
head by pulling head firmly forward. Slight twisting action may be required if
head does not slide off easily.
To remove cutter blades from shear head, remove 3 cap screws from shear
housing. Be careful not to lose rear spacer bushing when removing middle
SPACER
cap screw. Remove center blade from housing by tapping blade gently
BUSHINGS
towards the rear. Side knife and side spacer will now drop out of the housing.
To remove eccentric bearing assembly from shaft, use an appropriate
wrench to loosen eccentric nut by turning counterclockwise.
SIDE KNIFE AND
Figure 3
SIDE SPACER
2
Advertisement
