Bearing Pointer Source; Gps Identifier And Distance - Honeywell BENDIXKing APEX EDGE Series Pilot's Manual

The circle bearing pointer is a single line pointer with the O symbol
between the center and the pointer tip. The diamond bearing pointer
is a double line pointer with the
pointer tip. Therefore, when the pointers lie over each other, both
pointers and their identifying symbols are seen.
The full menu of navigation selections is displayed even if that
navigation unit is not installed.

Bearing Pointer Source

If the bearing data is invalid, the bearing pointer is removed. If the
bearing source is GPS and magnetic variation data is invalid, the
bearing pointer is removed.

GPS Identifier and Distance

Distance to the waypoint is displayed below the waypoint identifier.
The distance is displayed with a resolution of 1 nm, for distances of
100 nm or more and a resolution of 0.1 nm for distances less the 100
nm.
Time to the waypoint is displayed below the distance.
KFD 840 PG PN 7450-0840-01
Rev C May 28, 2010
© Honeywell International Inc. Do not copy without express permission of Honeywell
Honeywell Bendix/King KFD 840 Primary Flight Display
◊
symbol between the center and
The bearing pointer source is selected
with the O BRG and
on the unit. The digital bearing to the
station is displayed next to the
selected source. If the bearing data is
invalid the readout displays amber
dashes.
The
distance readout are displayed
near the upper right corner of
the HSI. The source for this
data is GPS only. The KFD 840
does not display any DME data.
◊
BRG soft keys
waypoint identifier and
HSI Area
7-7