Honeywell X-618 Commissioning Manual page 28

Audio Type: Play List and Net Audio.
 Play List: usually used for voice broadcast, background music etc. The users also can
add the prompt tone files into the play list as needed.
 Net Audio: Mainly external audio sources connected through NRI or X-DCS3000 inner
or external voice, which can be selected through the drop - down menu.
c. Policy:

Delay: Edit this field to specify a time in the range of 0~600 second for which the
audio is delayed before being played.
 Priority: The range of the value is different based on different task type. The Normal
and Emergency task values must be between 56 ~ 255 and 1 ~ 55 respectively. If
many play tasks are set to broadcast to the same zones simultaneously, the highest
priority one would be played. And the smaller the value is, the higher the priority.
 Loop: This item is available only to that selected audio type being play list or record
file. It is used to set the play times in the range is 1~65535.
 Forever: Enable/disable forever loop playback.
 Preview: Check the check box or not to enable/disable the function which supports
confirming the play contents according to auditioning them by the device's built-in
speakers in advance.
 Busy wait: check the check box to enable the lower priority task which was in conflict
with a higher priority one plays when the running task finished. Otherwise the task
would be canceled automatically.
 Resume: Enable or disable the shortcut task which was be broken off by the higher
priority task resumes automatically when the insert task finished.
 Full: Mainly used in emergency broadcast to keeps integrality of the new added task
that comes the same audio source and play policy. If the check box is selected, the
two combined tasks will be broadcasted from the beginning after the waiting audio
and vice versa.
d. Speaker Lines: Select the appropriate broadcast zones. Because of the tasks configured
for X-DCS3000 can be only broadcasted in the local zones, the most 8 zones can be
selected. Click
e. Dry Contact Output: Check the dry contact match zones check box, and the dry port
output corresponds one-to-one with the zones. For example, the Zone 1 runs the Port 1
enables. The function is used for volume controller.

Editing Play Task
Select one play task in the task list, and click
or double left click, the Edit window is displayed. The user can edit the parameters like those
above as needed.

Deleting Play Task
Select one play task in the task list, and click
the deleting confirmation window is displayed, and click YES to delete that task.
to select all, and click
icon in the upper right corner of the task list
icon in the upper right corner of the task list,
to cancel all.
27