Table of Contents
Advertisement
Comment
Next Filter Set
To edit Filter Rule, click the Filter Rule index button to enter the Filter Rule setup page.
Comments
Check to enable the
Filter Rule
Pass or Block
Branch to other Filter
Set
Log
Direction
Protocol
IP Address
Vigor3100 Series User's Guide
Enter filter set comments/description. Maximum length is
23–character long
Set the link to the next filter set to be executed after the current filter
set. Do not make many filter sets a loop.
Enter filter set comments/description. Maximum length is 14-
character long.
Check this box to enable the filter rule.
Specifies the action to be taken when packets match the rule.
Block Immediately - Packets matching the rule will be dropped
immediately.
Pass Immediately - Packets matching the rule will be passed
immediately.
Block If No Further Match - A packet matching the rule, and that
does not match further rules, will be dropped.
Pass If No Further Match - A packet matching the rule, and that
does not match further rules, will be passed through.
If the packet matches the filter rule, the next filter rule will branch
to the specified filter set. Select next filter rule to branch from the
drop-down menu.
Check this box to enable the log function. Use the Telnet command
log-f to view the logs.
Set the direction of packet flow. It is for Data Filter only. For the
Call Filter, this setting is not available since Call Filter is only
applied to outgoing traffic.
Specify the protocol(s) which this filter rule will apply to.
Specify a source and destination IP address for this filter rule to apply
to. Place the symbol "!" before a specific IP Address will prevent this
rule from being applied to that IP address. To apply the rule to all IP
address, enter any or leave the field blank.
57
Advertisement
Table of Contents
