Advertisement
Tetra
EdgeStrip
®
Components and Tools Required
2
1
UL approved 18 AWG (0.82 mm
1
2
UL approved 22-14 AWG (0.33-2.08 mm
connectors or 22-18 AWG (0.33-0.82 mm
connectors
3
#6 or #8 (M3 or M4) screws, 1/8 inch
(3.2 mm) rivets or electrical grade silicone
4
End caps
5
24 Volt Power Supply
Layout LED Modules
Sign
Modules mounted to sides
1
Determine location of where LED modules will
be mounted based on sign dimensions (see
chart). If mounting on bottom of sign, the use of
a riser will be needed (minimum 1/8 in. distance
between bottom surface and module).
3
Peel off backing to expose adhesive tape and stick
LED modules into place.
3
5
4
) supply wire
2
) wire
2
) in-line/IDC
2
2
6
T
Measure Point
C
6
Tetra
®
EdgeStrip LED modules
Electrical grade RTV silicone.
7
Example electrical grade RTV silicones include:
• Momentive RTV 6700 Series Silicone Rubber
Adhesive Sealant
• Momentive White Blanc RTV 162 Silicone Rubber
Adhesive Sealant-Electrical Grade
• Dow Corning 3140 - Non-Corrosive Flowable (clear)
• Dow Corning 3145 - Non-Corrosive Nonflowable
(clear or gray)
• Dow Corning RTV 748 Non-Corrosive Sealant-White
2
Determine how many modules are required for
your application and cut where necessary.
NOTE: Cuts can be made between any of the LED
modules.
4
Use rivets, screws, or silicone to secure each
module within the sign. Use #6 (M3) or #8 (M4)
screws, 1/8-inch (3.2 mm) rivets, or silicone.
Installation Guide
7
Advertisement
