Bosch INTEGRUS Installation And Operating Manual page 43

INTEGRUS | Installation and Operating Manual | Infra-Red Radiators
Mounting on a floor stand
The top of the floor stand is screwed into the suspen-
sion bracket (figure 3.5). The bracket is supplied with
both metric and Whitworth threaded plates, and is
therefore compatible with most standard floor stands.
For floor stands, the mounting angle can be set at 0°,
15° or 30°.
Figure 3.5 Attaching the stud of a floor stand to the
suspension bracket of the radiator
Figure 3.6 Attaching the radiator inclusive suspension
bracket and stud to the floor stand
Bosch Security Systems | 2003-02 | 3122 475 22011en
Wall mounting
For wall mounting, an extra wall bracket (LBB
3414/00) is required (must be ordered separately).
This bracket is attached to the wall by means of four
bolts (see figure 3.8). Four holes of 10 mm in diameter
and 60 mm in depth must be drilled using the drilling
pattern (see figure 3.7).
Note: The four bolts used to attach the
bracket must each be able to withstand
a pull-out force of 200 kg (440 lb).
The bolts and plugs delivered with the
LBB 3414/00 wall bracket are only
intended for mounting the unit on a solid
brick or concrete wall.
Figure 3.7 LBB 3414/00 wall mounting bracket showing
dimensions and drilling pattern
en | 37