off
off
on/steady
on/steady
on/steady
on/steady
flashing
flashing
flashing
Testing Your DP-100
The PS Admin software includes a Print Test function for confirmation of
printer cable connections and functions.
completed after you have installed the PS Admin software, and have
configured your DP-100 and its ports. See the Testing Your Print Server
section of the Print Server Administration User's Guide.
Wall-Mounting the DP-100
The bottom of the DP-100's case has a pair of wall-mount sockets, and
screws and nylon anchors are supplied, to facilitate mounting the DP-100 to
a wall or partition adjacent to your printers.
To mount the DP-100 with the front panel facing up (and the printer port
connectors facing down), set the two mounting screws at the lower-left and
upper-right corners of a rectangle as shown below (actual size):
Unpacking and Installation
DP-100 Multiprotocol Ethernet Print Server User's Guide
flashing
on/steady
flashing
flashing
off
off
on/steady
off
flashing
on/steady
off
flashing
flashing
flashing
EEPROM error
Flash Protected
off
LPT1 error
Timer INT error
LAN IO Base error
off
RAM error
off
Parallel-1 Controller error
off
Flash erase/program error
Need to reload firmware
That operational test can be
9