Network Setup Screen - Linksys LAPAC1750 User Manual

Network Setup Screen

Use this screen to configure basic device settings, VLAN settings and settings for the LAN
interface, including static or dynamic IPv4/IPv6 address assignment.
Data - Network Setup Screen
TCP/IP
Assign a host name to this access point. Host name consists of 1 to 15
Host Name
characters. Valid characters include A-Z, a-z, 0-9 and -. Character
cannot be first and last character of hostname and hostname cannot be
composed of all digits.
VLAN Enables or disables VLAN function.
Enables or disables VLAN tagging. If enabled (default), traffic from
Untagged VLAN
the LAN port is untagged when the following conditions are met: 1)
VLAN ID is equal to Untagged VLAN ID and 2) untagged traffic can
be accepted by LAN port. If disabled, traffic from the LAN port is
always tagged and only tagged traffic can be accepted from LAN port.
By default all traffic on the access point uses VLAN 1, the default
untagged VLAN. All traffic will be untagged until you disable the
untagged VLAN, change the untagged traffic VLAN ID, or change the
VLAN ID for a SSID.
Untagged VLAN Specifies a number between 1 and 4094 for the untagged VLAN ID.
The default is 1. Traffic on the VLAN that you specify in this field is
ID
not be tagged with a VLAN ID when forwarded to the network.
Untagged VLAN ID field is active only when untagged VLAN is
enabled.
VLAN 1 is the default for both untagged VLAN and management
VLAN.
Figure 14: Network Setup Screen
16