Table of Contents
Advertisement
OPERATION
005173
Adjust the amount of water flow. Hold the tool firmly. Set
the base plate on the workpiece to be cut without the
wheel making any contact. Then turn the tool on and
wait until the wheel attains full speed. Now simply move
the tool forward over the workpiece surface, keeping it
flat and advancing smoothly until the cutting is
completed. Keep your cutting line straight and your
speed of advance uniform.
CAUTION:
THIS TOOL SHOULD ONLY BE USED ON
•
HORIZONTAL SURFACES.
Be sure to move the tool forward in a straight line
•
and gently. Forcing and exerting excessive
pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor
and dangerous kickback of the tool.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
After use
Blow away dust from the inside of the tool by running
the tool at an idle for a while. Brush off accumulation of
dust on the base. Accumulation of dust in the motor or
on the base may cause a malfunction of the tool.
Cleaning covers
1
013266
When accumulation of dust on the cover (A) looks
excessive, loosen the clamp and remove the cover (A).
Wash off accumulation of dust inside the cover (A) and
wipe it. Then hold the cover (A) with its brim facing
below, push it as far as it will go and secure it by
tightening the clamp.
When changing the wheel, clean the cover (B) at the
same time. Loosen the screw securing the cover (B)
and remove the cover (B). Wash off accumulation of
dust inside the cover (B) and wipe it. Then attach the
cover (B) to the tool by tightening the screw.
Accumulation of dust inside the covers may cause a
malfunction of the tool.
1
2
005175
CAUTION:
When using the tool, be sure to attach the covers
•
(A) and (B).
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
First, remove the cover (A).
7
1. Clamp
2. Cover (A)
2
1. Cover (B)
2. Screw
1. Limit mark
1
Advertisement
Table of Contents
