Table of Contents
Advertisement
Sighting
005166
Align the notch in the front of the base with your cutting
line on the workpiece.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
1
005167
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing diamond wheel
1
2
005169
Hold the outer flange with the offset wrench and loosen
the hex bolt counterclockwise with the socket wrench.
Then remove the hex bolt, outer flange and diamond
wheel.
1. Notch
1
1. Switch trigger
1. Offset wrench
2. Socket wrench
To install the wheel, follow the removal procedure in
reverse. Always install the wheel so that the arrow on
the wheel points in the same direction as the arrow on
the blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
2
1
3
4
005170
CAUTION:
Use only the Makita wrench to install or remove
•
the wheel.
The inner flange has a 25 mm diameter on one side and
25.4 mm diameter on the other. The side with 25.4 mm
diameter is marked by "25.4". Use the correct side for
the hole diameter of the wheel you intend to use.
Mounting the wheel on the wrong side can result in
dangerous vibration.
2
1
25
25.4
3
005171
Water flow
1
005172
Attach the vinyl tube onto the water pipe and attach the
adapter on the vinyl tube to a faucet of water mains
pressure. Adjust the amount of water flow by simply
adjusting the water cock.
CAUTION:
Adjust the water cock so that the water flow rate
•
does not exceed 1.2 liters per minute.
6
1. Hex bolt
2. Diamond wheel
3. Outer flange
4. Inner flange
1. Mounting shaft
2. Inner flange
6
3. 25.4 mm
marking
4. Diamond wheel
25
5. Outer flange
5
6. Hex bolt
4
1. Water cock
Advertisement
Table of Contents
