Makita BUH481 Instruction Manual page 11

2
1
3
4
012481
If the sleeves are still left in the holes of the gear,
remove the gear and push the sleeves out of it with a
screwdriver or the like.
NOTE:
The washer underneath the gear may come off by
mistake when removing the gear. In this case, return it
to the original position as it was installed.
Installing the shear blade
1
012450
Remove the blade cover from the old shear blades and
fit it onto the new ones to avoid contact with blades.
012490
Adjust the hole positions by turning the gear as
illustrated.
1
012454
1. Gear
2. Sleeves
3. Washer
4. Groove
1. Blade cover
1. Grease
11
1
012455
Apply some grease provided with the new shear blades
as illustrated.
1
3
012482
Put the removed sponge in the same position as the old
one. Make sure that the sleeves provided with the new
shear blades are put on the pins of the blade. Place the
new shear blades on the tool so that the pins fit in the
holes of the gear. If the sleeves on the pins come off
mistakenly, put them into the holes of the gear
beforehand.
1
012452
Install the blade and tighten the four screws and put the
removed washer in the same position as the old one.
1
012446
Install the under cover on the tool and tighten the four
screws firmly.
1. Grease
1. Blade
2. Sponge
2 3. Sleeves
1. Screws
2. Washer
1
2
1. Screws