Cleaning And Maintenance - Whirlpool W7 OM5 4 H Quick Manual

CLEANING AND MAINTENANCE

Make sure that the oven has
cooled down before carrying out
any maintenance or cleaning.
Do not use steam cleaners.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If
any of these products inadvertently comes into
contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues. To
dry any condensation that has formed as a result
of cooking foods with a high water content, let the
oven to cool completely and then wipe it with a
cloth or sponge.
CLEANING THE CATALYTIC PANELS (ONLY IN SOME MODELS)
This oven could be equipped with special catalytic
liners that facilitate cleaning of the cooking
compartment thanks to their special self-cleaning
coating, which is highly porous and able to absorb
grease and grime. These panels are fitted to the shelf
guides: When repositioning and then refitting the
shelf guides, make sure that the hooks at the top are
slotted into the appropriate holes in the panels.
REPLACING THE LAMP
1. Disconnect the oven from the power supply.
2. Unscrew the cover from the light, replace the bulb
and screw the cover back on the light.
3. Reconnect the oven to the power supply.
10
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the
appliance.
• Activate the "Smart Clean" function for optimum
cleaning of the internal surfaces.
• Clean the glass in the door with a suitable liquid
detergent.
• The oven door can be removed to facilitate
cleaning.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
To make best use of the catalytic panels' self-cleaning
properties, we recommend heating the oven to
200 °C for around one hour using the "Convection
Bake" function. The oven must be empty during
this time. Then leave the oven to cool down before
removing any remaining food residues using a non-
abrasive sponge.
Please note: Using corrosive or abrasive cleaning agents, stiff
brushes, pan scourers or oven sprays could damage the
catalytic surface and compromise its self-cleaning properties.
Please contact our After-sales Service if you require
replacement panels.
Please note: Only use 20-40 W/230 ~ V type G9, T300°C
halogen bulbs. The bulb used in the product is specifically
designed for domestic appliances and is not suitable for
general room lighting within the home (EC Regulation
244/2009). Light bulbs are available from our After-sales
Service.
- If using halogen bulbs, do not handle them with your bare
hands as your fingerprints could cause damage. Do not use
the oven until the light cover has been refitted.
Wear protective gloves.
The oven must be disconnected
from the mains before carrying
out any kind of maintenance
work.