Makita LS004G Instruction Manual page 24

Use upper fences to support the material higher than
the lower fences. Insert the upper fence into the hole on
the lower fence and tighten the clamping screw.
3
4
1
2
► 1. Upper fence 2. Lower fence 3. Clamping screw
4. Adjusting screw
NOTICE:
The lower fences are fixed to the base
in the factory. Do not remove the lower fences.
NOTICE:
If the upper fence is still loose after
tightening the clamping screw, turn the adjusting
screw to close a gap. The adjusting screw is factory
adjusted. You don't need to use it unless needed.
When not using the upper fence, you can store it onto
the holder. Use the clip on the upper fence to hold it on
the holder.
3
► 1. Holder 2. Upper fence 3. Clip
1
2
4
3
2
1
Vertical vise
WARNING:
firmly against the turn base and guide fences with
the vise during all operations. If the workpiece is
not properly secured against the fences, the material
may move during the cutting operation causing pos-
sible damage to the circular saw blade, causing the
material to be thrown and loss of control resulting in
serious personal injury.
The vertical vise can be installed in either the left or
right side of the base. Insert the vise rod into the hole
in the base.
1
2
► 1. Vertical vise 2. Hole for vertical vise 3. Base
1
2
3
4
► 1. Vise arm 2. Vise rod 3. Clamping screw 4. Vise
knob
Position the vise arm according to the thickness and
shape of the workpiece and secure the vise arm by
tightening the screw. If the clamping screw contacts the
carriage, install the vertical vise into the opposite side of
the base. Make sure that no part of the tool contacts the
vise when lowering the handle all the way. If some part
contacts the vise, re-position the vise.
Press the workpiece flat against the guide fences and
the turn base. Position the workpiece at the desired
cutting position and secure it firmly by tightening the
vise knob.
24 ENGLISH
The workpiece must be secured
3
2