Makita XCU03 Instruction Manual page 47

Angle setting of the handle
CAUTION:
Always make sure that the handle
is locked in the desired position before operation.
CAUTION:
Do not pull down the lever to
unlock the handle while pulling the switch trigger.
Do not pull the switch trigger while pulling down
the lever and turning the handle. Failure to do so
You can set the angle of the handle to 0°, 45°, or 90° to the
left or right. To change the angle of the handle, turn the han-
dle while pulling down the lever, and then release the lever.
1. Lever
Power switch action
WARNING:
For your safety, this tool is
equipped with lock-off lever which prevents the
tool from unintended starting. NEVER use the tool
if it runs when you simply press the switch lever
and pull the switch trigger without pressing the
lock-off lever. Return the tool to our authorized
service center for proper repairs BEFORE further
usage.
WARNING:
NEVER tape down or defeat pur-
pose and function of lock-off lever.
WARNING:
Before installing the battery car-
tridge on the tool, always check to see that the
switch trigger and switch lever actuate properly
and return to the "OFF" position when released.
Operating a tool with a switch that does not actuate
CAUTION:
switch when carrying.
NOTICE:
Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
1
-
-
Press and hold the main power button to turn on the tool.
The power lamp lights up when the tool is turned on. To
turn off the tool, press and hold the main power button
again. The power lamp goes off when the tool is turned off.
1. Power lamp 2. Main power button
NOTE:
not operated for a certain period.
a lock-off lever is provided. To start the tool, depress the
lock-off lever, and then press the switch lever and pull the
sure on the switch trigger. Release the switch trigger to stop.
1. Switch lever 2. Lock-off lever 3. Switch trigger
Speed adjusting
speed will change.
2
1. Power lamp 2. Main power button
7 ENGLISH
1
2
1
3
1
-
2