Vga Display Identification; Dvi Display Identification; Usb Support (Option); Ddc /Ci Support And Smart Manage - Philips 223V5LSB/00 Service Manual

136 Meridian 5
CC170C
measurement of
W8 LCD
power saving.pdf
C

3.9 VGA Display Identification

C
In accordance with VESA Display Channel Standard Ver. 1.0 and DDC 2B capability

3.10 DVI Display Identification

In accordance with DVI requirement (DDWG digital Visual Interface revision 1.0)
use DDC-2B, DDC/CI, and EDID V1.3

3.11 USB support (option)

Connect the upstream port of the monitor to host PC's USB port via USB cable. Then attach
external device to the downstream port of the monitor. Check if the device can work properly.
3.12 DDC /CI Support and Smart Manage/Control
In accordance with VESA DDC/CI and MCCS ver.2.0, the monitor should be workable with ,
Philips Smart Manage, Smart Control V6.1, and Protrait Display Tune at least.

3.13 Pivot function(Auto pivot) (option)

It needs to support AUTO PIVOT function with SmartControl PC application tool.

3.14 Hot-key definition

D:\ENG\monitor
projects\spec\H8\hot key\Hot key operation for Hudson 8 Monitors.xls

3.15 Smart image(option)

3.16 PerfectTune II (formerly FGA, FACTORY GAMMA Alignment) (option)
A. PerfectTune must be done after warming 30 minutes at least.
B. PerfectTune must be performed after Auto Color.
C. PerfectTune must be conducted through DVI or scaler embedded patterns.
D. Delta E < 2.5

3.17 Audio

3.17.1 Frequency Response
The amplifier and speaker combination shall provide a frequency response of 300 Hz to
20 kHz, with +/- 3 dB variation over the entire response range.
3.17.2 Total Harmonic Distortion
Total harmonic distortion shall be limited to 5% THD at the maximum wattage speaker
rating specified in section 1.3, at 1 kHz, when the input is 1.0Vrms.
3.17.3 Power Handling
Each speaker transducer shall accept up to the specified Wattage of audio power
without damage or exceeding the frequency response and total harmonic distortion
specifications.
3.17.4 Audio Amplifier
The amplifier shall provide two channels of audio up to 2 Watts per channel from 100 Hz
to 20 kHz, based upon an audio signal input of 1.0V RMS per channel.
Power consumption
measure the way -090518.pdf
Smart Image.doc