Advertisement
Step 7: Thread the power button cable through the hole for the power button. Plug the cable into the
front panel connector (the 2nd connector from the front, CN3 in user manual), then gently push the
power button in until it is secure (you will hear a 'snap'). NOTE: Be careful not to tangle the power
button cable with the CMOS battery cable.
Step 8: Peel the backing off of the tape on the CMOS battery. Gently press the battery onto the PICO-
KBU4 board to secure it.
Step 9: Attach the bottom chassis by first lining up the right side, then swivel the chassis into place.
NOTE: the bottom chassis does not slide directly on, it must swivel into place as shown in the figure.
Step 10: Ensure the bottom chassis is properly lined up and attached. Use black screws to secure, two
screws on the bottom and one screw on the left and right sides of the chassis.
Step 11: Replace the washer and nut for the power input port.
Advertisement
