Cisco ASR1002 Installation Manual page 24

Attaching the Cable-Management Bracket
Make certain that the cable-management bracket "U" type feature is facing upwards when you attach it
Note
to the chassis.
Follow these steps to attach the cable-management brackets to both sides of the Cisco ASR 1002 Router
in the rack:
Align the cable-management bracket to the rack-mount bracket on one side of the Cisco ASR 1002
Step 1
Router. The cable-management bracket aligns to the top hole of the chassis rack-mount bracket.
Using a Phillips screwdriver, insert the screw through cable-management bracket and into the chassis
Step 2
rack-mount and tighten the screw.
Note
Figure 8-16
Router in a rack.
Figure 8-16
1 Secure the cable-management top screw and
bottom to this ear hole
2 Cable-management bracket
Step 3 Using the bottom rack-mount ear hole, insert the screw through cable-management bracket and into the
chassis rack-mount (see
This completes the procedure for installing the cable-management brackets on the chassis.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-24
Use the package of four screws.
shows the locations at which to attach the front rack-mount brackets to the Cisco ASR 1002
Chassis Rack-Mount Bracket Ear Holes for the Cable-Management Brackets
3
2
Figure 8-16).
Chapter 8
1
CON
AUX
MGM T
LINK
MTS
CAR RIER
BOO T
QE3
QE2
QE1
QE0
STA T
AS R 10 02
mi n
sta t
ma j
pw r
OS
SPA -4XO C3-P
cri t
1
3 Front rack-mount bracket
Cisco ASR 1002 Router Overview and Installation
SPA -4XO C3-P OS
T
PWR STA
OS
SPA -4XO C3-P
OL-13208-09