Installing The Side Wall Bracket - Dell EMC PowerEdge R750 Installation And Service Manual

Next steps
1. Replace the side wall

Installing the side wall bracket

There are two side wall brackets on either side of the system. The procedure to install is similar.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the front
4. Remove the drive backplane
5. If installed, remove the air shroud
6. Remove the cooling fan
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the guide slots on the side wall bracket with the guides on the system and slide until the cover is seated firmly.
NOTE: Route the cables through the side wall cable holder.
2. Close the side wall cable holder until the holder clicks into place.
Figure 77. Installing the side wall bracket
Next steps
1. Replace the cooling fan
2. If removed, install the air shroud
3. Install the drive backplane
78 Installing and removing system components
bracket.
Safety
Before working inside your
bezel.
cover.
or remove the GPU air
assembly.
assembly.
or install the GPU air
cover.
instructions.
system.
shroud.
shroud.