Removing The Left Control Panel - Dell EMC PowerEdge R750 Installation And Service Manual

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air shroud
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secures the left control panel and the cable cover to the system.
2. Remove the cable cover away the system.
3. Disconnect the control panel cable from the connector on the system board.
4. Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the right control panel from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 218. Removing the left control panel
Next steps
1. Replace the left control
210 Installing and removing system components
Safety
Before working inside your
cover.
or remove the GPU air
assembly.
bracket.
panel.
instructions.
system.
shroud.