Miter Cutting; Bevel Cut - Makita GSL02 Instruction Manual

4. Gently lower the handle to the fully lowered posi-
tion to cut the workpiece.
5.
When the cut is completed, switch off the tool and
wait until the circular saw blade has come to a com-
plete stop before returning the circular saw blade to its
fully elevated position.
1
► 1. Stopper pin
Slide (push) cutting (cutting wide
workpieces)
WARNING:
Whenever performing a slide cut,
first pull the carriage full towards you and press
the handle all the way down, then push the car-
riage toward the guide fence. Never start the cut
with the carriage not pulled fully toward you. If
you perform the slide cut without the carriage pulled
fully toward you, unexpected kickback may occur and
serious personal injury may result.
WARNING:
Never attempt to perform a slide
cut by pulling the carriage towards you. Pulling
the carriage towards you while cutting may cause
unexpected kickback resulting in possible serious
personal injury.
WARNING:
Never perform the slide cut with
the handle locked in the lowered position.
1.
Unlock the stopper pins so that the carriage can
be elevated and slid freely.
2. Secure the workpiece with the proper type of vise.
3. Pull the carriage toward you fully.
4. Switch on the tool without the circular saw blade
making any contact and wait until the circular saw blade
attains full speed.
5. Press the handle down and push the carriage
toward the guide fences and through the workpiece.
6. When the cut is completed, switch off the tool and
wait until the circular saw blade has come to a com-
plete stop before returning the circular saw blade to its
fully elevated position.
2
► 1. Stopper pin for handle lock 2. Stopper pin for
slide lock

Miter cutting

Refer to the section for adjusting the miter angle.

Bevel cut

WARNING:
blade for a bevel cut, ensure that the carriage and
circular saw blade will have free travel throughout
the entire range of the intended cut before oper-
ating the tool. Interruption of the carriage or circular
saw blade travel during the cutting operation may
result in kickback and serious personal injury.
WARNING:
hands out of the path of the circular saw blade.
The angle of the circular saw blade may confuse the
operator as to the actual blade path while cutting and
contact with the circular saw blade will result in seri-
ous personal injury.
WARNING:
be raised until it has come to a complete stop.
During a bevel cut, the piece cut off may come to
rest against the circular saw blade. If the circular saw
blade is raised while it is rotating, the cut-off piece
may be ejected by the circular saw blade causing
the material to fragment which may result in serious
personal injury.
24 ENGLISH
1
After setting the circular saw
While making a bevel cut, keep
The circular saw blade should not