Table of Contents
Advertisement
INSTALLATION
3.3
DOOR ADJUSTMENT:
If the doors do not align horizontally, they can be
adjusted using the adjustment mechanism in the sill
rail.
Check the vertical gap between the doors , to be
adjusted and the adjacent sets of doors, to see which
door is the one to be adjusted. Make small adjustments
each time. Both doors may need to be adjusted to
achieve the most even result.
SCHOTT DOOR :
To resolve the doors misalignment as shown in below
image adjustment should be done through the hinge
mechanism at the top of door assembly.
FIGURE 3K
The hinge mechanism by default is set in the middle of
the rebate. Shifting the hinge left or right can be done
by untightening of two screws as shown in (Figure 3N).
PAGE 17
Slide
Hinge mechanism in middle of rebate
If the doors cant be adjusted through the hinge
mechanism, then the case needs to be levelled correctly.
Doors after adjustment and cancelling of misalignment
SMED SEMI VERTICAL - HUSSMANN
FIGURE 3L
FIGURE 3M
Advertisement
Table of Contents
