Table of Contents
Advertisement
INSTALLATION
3.2
DOOR SAW TOOTHING
SCHOTT DOOR :
The doors in the images below show the misalignment
(saw toothing) . This should be completely horizontal
and flush with each other. The door system on this
case only has a minor adjustment. If doors cannot be
aligned as per the following examples then the case
chassis has not been leveled to tolerance and needs to
be readjusted.
SCHOTT DOOR
Misaligned / Not Parallel/ Twisted
FIGURE 3G
SCHOTT DOOR
Aligned / Parallel / Not Twisted
FIGURE 3H
PAGE 16
SCHOTT DOOR
SCHOTT DOOR
BENTCAM DOOR:
NOTE:
IF SAW TOOTHING OF DOORS
IS EVIDENT THEN IT IS HIGHLY LIKEY
FURTHER ADJUSTMENT IS REQUIRED.
BENTCAM DOOR
Misaligned / Not Parallel/ Twisted
BENTCAM DOOR
Aligned / Parallel / Not Twisted
Case needs to be re-checked for level once fully
stocked. If door saw toothing is apparent and doors
cannot be re-adjusted, then case needs to be re-
levelled correctly.
SMED SEMI VERTICAL - HUSSMANN
BENTCAM DOOR
FIGURE 3I
BENTCAM DOOR
FIGURE 3J
Advertisement
Table of Contents
